Service Manual

40
GTS 200
Electric
Starter
Battery
Handling Instructions
CAUTION
LIKE
ALL batteries, these units contain corr
osive
fluids and toxic materials and should be handled
with car
e.
Do not puncture, disassemble, mutilate or incinerate.
As with all rechar
geable batteries, explosive gases could
be vented during char
ge or dischar
ge. Use in a well
ventilated area, away from sources of ignition.
Battery should be rechar
ged by adults only
.
Use only the battery charger specified.
Do not make direct contact between the positive and
negative terminals as this could cause high current flow
,
creating high heat and the possibility of a fire.
A
void any direct connection of battery terminals that will
cause the battery to short out.
First Aid
CAUTION
IF
THE battery case cracks or br
eaks open as the
r
esult of sever
e abuse and some of the liquid
comes in contact with skin or clothing, follow
these instructions:
External Contact – Immediately flush skin or
eyes with water for at least 15 minutes.
Internal Contact – Drink tap water
, milk, or
milk of magnesia. T
ake whites of eggs. Do not
induce vomiting.
WARNING
IN CASE of external or internal contact, call a
physician immediately
.
Check Battery
1. Physical
check – clean if necessary
.
A. Corrosion
B. Dirt
C. T
erminal – clean, undamaged. Replace if damaged
with T
oro Part #49–8141.
2.
Fully char
ge battery with char
ger supplied with the mower
.
3.
Install battery on mower
. Plug into wire harness.
4.
Slightly loosen battery plug and attach DC voltmeter
.
Reading should be around 12.5 VDC.
5.
Disconnect spark plug wire and turn switch to start.
6.
Battery should maintain 9 volts or more while cranking
engine. If it is less than 9 volts, replace battery
.
Alternate method: T
est using T
oro Keylectric tester
, T
oro Part
#67–7970, Fig. 90. Instructions provided on tester
.
Fig. 90
– Keylectric T
ester
CAUTION
DO
NOT crank starter motor for mor
e than 15
seconds without cooling starter 2 minutes.
Replace Battery Terminal
Toro
Part #49–8141 is a replacement plug with two solderless
connectors (Fig. 91). It can be used when the plug or lead
wires between the plug and battery are damaged.
Fig. 91
– Replacement Battery T
erminal
T
oro Part #49–8141