Service Manual
3.
Install a single
3/8"
hex, washer head cap screw
in
the
front mounting bracket of the muffler. Torque the
screw to
85
in Ibs
(9.5
N-m)
Muffler Shroud
Installation
1.
Install the shroud with
two
3/8"
hex, washer head
screws
in
the rear of the shroud. Torque the screws to
50
in Ibs
(5.5
N-m)
2.
Install
two
5/16"
hex, cap screws
in
the front of the
muffler shroud. Torque the screws to
35
in
Ibs
(4
N-m).
See Figure
101.
..
Figure
101
Dipstick
lube
Installation
1,
Lubricate the
"0"
ring on the sealing end of the tube.
2.
Install the tube in the block.
3.
Mount the tube with
two
3/8"
hex, washer head cap
screws. Torque the screws to
35
in Ibs
(4
N-m)
See
Figure
102
and
103.
Figure
102
Engine
Figure
103
Fuel
Tank
lnstallatlon
1.
Mount the fuel tank with
two
3/8"
hex, washer head
cap screws. Torque the screws to
45
in Ibs
(5
N-m)
.
2.
Install the fuel hose. With electric start models, route
the fuel hose around the electric starter.
3.
Install
a
hose clamp on the fuel tank and carburetor
ends
of
the fuel hose.
Blower Shroud
-
Installation
1.
Install the blower shroud and secure
it
with four
3/8'
hex, washer head cap screws. Torque the screws to
50
in Ibs
(5.8
N-m) See Figure
104.
Figure
104
Rewind Starter
-
Installation
1.
Make sure the alignment pin is installed in the drilled
hole in the rewind starter mounting screw. See Figure
105.
GTS
150