Service Manual

Carburetor - Operation
See Section
1 - Carburetor, page 19.
Carburetor - Removal
1. Note the position of the choke over-center spring
before removal. This will aid proper reinstallation. The
long hook end of the spring is attached to the carbu-
retor shaft. Unhookthe choke over-center spring. See
Figure
43.
Figure 43
2. Remove the two 3/8” hex, washer head shoulder
screws that retain the carburetor. See Figure
44.
CARBURETOR
GASKET
Figure 44
3. During removal, rotate the body of the carburetor and
unhook the throttle lever from the governor control
rod.
4. The insulator/gasket may now be removed.
Ignition Coil
- Operation
See Section
3 - Ignition, page 25.
lgnltion Coil - Removal
1. Note the routing of the ignition ground (kill) wire, this
will make reinstallation easier. Disconnect the ignition
ground wire from the terminal on the back of the
throttle bracket. See Figure
45.
2. Disconnect the ignition coil high tension wire from the
spark plug.
3. Remove the two 5/16" hex head screws retaining the
ignition coil. The coil may now be lifted away from the
engine. See Figure
46.
IGNITION KILL
Figure 46
Throttle Bracket - Removal
1. Remove the two 3/8" hex, washer head screws that
retain the front blower shroud bracket.
2. Remove the two 3/8" hex, washer head screws that
retain the throttle bracket to the engine block. See
Figure
47.
Engine
32
GTS 150