Service Manual
3-6
WPM Drive Systems Manual
SINGLESPEEDSPUR/BEVELGEARTRANSMISSION
Insert the transmission back into the chassis. Refer
to the section on the wheel pinion clutch for assembly
instructions.
Install self-propel cable. Adjust as needed; see “Handles
and Control Cables” Section 7.
Finally, install the spacer and pulley on the input shaft.
The internal gears will help hold the pinion while the nut
is tightened (Fig. 038).
Assembly
Assemble with the correct number of thrust washers.
Refer to the parts manual if there is any doubt at all. It
is not possible to locate the shafts and bearings in the
wrong location, due to differences in sizes.
Prior to installation of oil impregnated bushings, it is
wise to apply a light coating of engine oil to the running
surface (Fig. 037). Add grease and install the cover.
Fig037 3428-0019
Fig038 3428-0022