Service Manual
9-17
WPM Drive Systems Manual
HANDLES&CONTROLCABLES
ToroBOSControl
The BOS control is the upper bail on the handle. For the
required 2 step engagement, there is a pivoting stop on
the right hand handle. Rotate it out of the way and then
pull the bail down for blade engagement (Fig. 300).
ToroBOSControlCableAdjustment
The blade clutch control is adjusted by removing the
cover between the engine and bag door. Loosen the
cable clamp and draw the cable to the rear to remove
the slack. Now push the cable outer jacket forward 5/8”
(1.5cm) and secure. This will create 5/8” (1.5cm) slack in
the cable (Fig. 301).
Fig300 MVC-102
A. Pivoting stop
A
Fig301 MVC-BOS457X