Service Manual

4-6
WPM Drive Systems Manual
SINGLESPEEDBEVELGEARTRANSMISSION
10. Remove the clip ring and thrust washer from each
end of the axle (the left side has 2 thrust washers,
the right side, one). The bearing, bearing retainer,
HOC plate, spring arm and pivot arm all come off as
one unit (Fig. 047).
9. Remove the two bolts and nuts securing each pivot
arm to the housing. There is a notch in the pivot arm
for clearance of a socket (Fig. 045).
Fig045 MVC-475a
The axle assembly will now drop out of the chassis
(Fig. 046).
Fig046 PICT-1857a
11. To disassemble the pivot arm assembly, compress
the components with two clamps or locking pliers
(Fig. 048).
Fig048 MVC-478
Fig047 PICT-1858a