Service Manual
8-28
WPM Drive Systems Manual
BBC/BOS/BCS
3. Bend the throttle control locking tab back slightly
and tap the throttle control from the control panel
with a rubber mallet. Place a piece of duct tape
over the heads of the handle and the BBC control
box mounting bolts. This will prevent control box
components from falling out of the handle during
disassembly.
4. Remove the three anged head screws securing the
control box halves.
5. Remove the two nylon locknuts securing the control
box to the handle and carefully remove the right
control housing half.
6. Slip the end of the BBC cable from the cable lever
and remove the cable (Fig. 236).
BBCCableRemoval(Recycler/RearBagger)
1. Loosen the cable clamp and pull cable out from
under the screw (Fig. 234).
Fig236 g 36
A. BBC cable lever B. BBC cable
2. Unhook the spring and cable from the bellcrank (Fig.
235).
Fig235 3428-0173
Fig234 3428-0172