Service Manual

6-5
WPM Drive Systems Manual
9. Rotate the transmission forward enough to remove
the (3) screws (#14) holding the belt guide (#13) to
the top of the transmission (#11). Remove belt guide
(Fig. 142).
5. Remove blade bolt(s) (A), blade support (B), blade
(C), and blade driver (D) (Fig. 140).
GENERALTRANSMISSIONS
®
Fig.140 004
6. Release traction cable guide bushing (Fig. 141).
Fig.141 005
1
3
2
4
10. Remove the old belt and install a new belt. If not
replacing the transmission reassemble in reverse
order. To replace the transmission see “22” Steel
Deck - Rear Axle Transmission Replacement” in
this chapter. Seeoperator’smanualforbladebolt
torquespecication.
Fig.142 rear drive-bg
12
13
14
11
D
A
B
C
7. Move traction cable up to allow the cable guide
bushing to pass through the larger upper hole. This
will provide enough slack to disconnect the cable
from the transmission (Fig. 141).
8. Disconnect cable from transmission (Fig. 141).