Service Manual

4-10
WPM Drive Systems Manual
SINGLESPEEDBEVELGEARTRANSMISSION
22”TORO&LAWN-BOYREAR
WHEELDRIVEMODELS
TransmissionRemovalandBelt
Replacement
On rear wheel drive models, it is necessary to separate
the rear drive assembly from the mower housing in order
to change the drive belt.
1. Drain fuel and oil from the engine.
2. Remove the single retaining screw from the center of
the bag door spring. Slide the door to one side and
remove it from the rear HOC side plates (Fig. 061).
4. Remove one of the mounting screws for the belt
guide and loosen the other. DO NOT bend the belt
guide (Fig. 059).
5. Slip the belt out of the crankshaft pulley and over the
blade (Fig. 060).
Fig060 MVC-491
Fig059 MVC-490
Note: Bladeremovedforclarity.Thebladecan
beremoved,butitisnotrequiredforbelt
replacement.
Fig061 MVC-733