Service Manual

9-12

WPM Drive Systems Manual

HANDLES&CONTROLCABLES

7. Slide the upper handle out of the top slide.

Reverse the process to assemble.

Note how the switch assembly, bail and control cable

are assembled before they are installed on the pin (Fig.

289).

3. Slide the pivot assembly, bail and the brake cable to

the right until the bail slides off the pin (Fig. 287).

Fig287 DSC-4899a

4. Continue sliding the pivot assembly and brake cable

off the pin.

5. Remove the shoulder bolt that the traction lever

pivots on and remove the traction lever.

6. Pull the pin out of the left hand handle. Note it

is snapped in and will require a locking pliers or

something similar to remove. When removed, the

springs will push the handle upwards (Fig. 288).

Fig288 DSC-4907a

Fig289 DSC-4908a

A. Traction lever C. Top slide

B. Pivot assembly