Operator's Manual

3353-459 Rev A

Setup

Important: Remove and discard the protective plastic

sheet that covers the engine.

Unfolding the Handle

Folding or unfolding the handle improperly can

damage the cables, causing an unsafe operating

condition.

S Do not damage the cables when folding or

unfolding the handle.

S If a cable is damaged, contact an Authorized

Service Dealer.

1. Install the blade control bar into the upper handle.

m-8233

2. Carefully move the upper handle forward until the

handle halves are in line and nest together.

m-8108

m-8109

3. Tighten the

upper handle

knobs as tight as

you can.

m-8095

4. Rotate the handle rearward.

m-8109

m-8110

5. Attach the handle

brackets (A) to the lower

handle sides.

Note: Insert a lock

washer between

each bracket and

knob, and tighten the

lower handle knob as

tight as you can by

hand.

m-8097