Operator's Manual

Maintenance
Note: Deter mine the left and right sides of the mac hine from the nor mal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the rst 5 operating
hours
Change the engine oil.
Before each use or daily
Check the engine oil level.
Ensure that the engine stops within 3 seconds after releasing the blade control
bar.
Clean grass clippings and dirt from under the mower.
Every 25 hours
Lubricate the rear wheel gears.
Replace the blade or have it sharpened (more frequently if the edge dulls quickly).
Every 50 hours
Change the engine oil.
Every 100 hours
Clean the cooling system (refer to your engine owner’s manual).
Replace the spark plug (refer to your engine owner’s manual).
Before storage
Empty the fuel tank before repairs as directed and before annual storage.
Yearly
Replace the air lter (more frequently in dusty operating conditions).
Check the spark plug (refer to your engine owner’s manual).
Refer to your Engine Operator’s Manual for any additional yearly maintenance
procedures.
Important: R efer to y our Engine Operator’ s Man ual f or additional maintenance pr ocedur es.
Preparing for Maintenance
1. Stop the engine and w ait for all mo ving par ts to stop .
2. Disconnect the spark plug wire from the spark plug
( Figure 31 ) before perfor ming any maintenance
procedure .
Figure 31
3. After perfor ming the maintenance procedure(s),
connect the spark plug wire to the spark plug .
Important: Bef or e tipping the mo w er to change
the oil or r eplace the blade, allo w the fuel tank to
r un dr y thr ough nor mal usa ge. If y ou must tip the
mo w er prior to r unning out of fuel, use a hand fuel
pump to r emo v e the fuel. Al w ays tip the mo w er
onto its side with the air filter up .
Tipping the mo w er may cause the fuel to leak.
Gasoline is flamma ble, explosi v e and can cause
per sonal injur y .
R un the engine dr y or r emo v e the gasoline with a
hand pump; nev er siphon.
Replacing the Air Filter
R e place the air filter yearly; re place it more frequently in
dusty operating conditions .
1. P erfor m the pre-maintenance procedures; refer to
Pre paring for Maintenance .
2. Use a screw dri v er to open the air filter co v er ( Figure
32 ).
12