Service Manual

5-11

WPM Drive Systems Manual

THREESPEEDTRANSMISSION

SpecialAssemblyNotesforToroVacu

Power/Lawn-BoyMedallion

1. Slip the gear selection cable into the shift fork lever

through the bottom as shown in Figure 130.

4. Slip the two rear end cap fasteners through the

safety shield guide wires then install. Tighten all four

end cap fasteners (Fig. 131).

Note: Endcapfastenertorque:225in-lbs.(26Nm)

2. Bring the transmission assembly into position

underneath the deck, making sure that the end

caps are on the outside of the housing. Before

securing, install the shift fork control arm onto the

shift fork and secure with the cotter pin. Place the

transmission and pivot arm assembly into the deck.

3. Loosely install the two front end cap fasteners.

5. Slip the traction belt into position on the transmission

pulley. Make sure that it does not bind on any of the

bosses.

6. Slip the end of the traction cable into the belt guide

bracket from the outside. Install the belt guide

bracket onto the top of the transmission, making

sure that the traction belt is inside the guide.

Note: Beltguidefastenertorque:130in-lbs.(15Nm)

7. Slip the black plastic transmission cover into place

making sure that the belt falls in the appropriate

grooves. Install the upper BBC cover with the two

anged head self-tapping capscrews. Make sure

that the top edge is trapped underneath the lip of the

housing.

Fig130 3428-0123

Fig131 3428-0122

A. End cap