Operator's Manual

Installing the Starter Rope

Pull the starter rope through the rope guide on the handle

(Fig. 4).

210

Figure 4

1. Rope guide 2. Starter rope

Installing the Discharge Tunnel

Plug

1. Stop the engine and wait for all moving parts to stop.

2. Open the discharge door by moving it rearward (Fig. 5).

1914

Figure 5

1. Discharge door handle 2. Discharge tunnel plug

3. Hold the discharge door handle to prevent the

spring-loaded door from closing while you insert the

discharge tunnel plug.

4. Rotate the plug clockwise slightly while inserting it

(Fig. 5).

Note: Ensure that the arrow on the plug decal points

upward.

5. Push the plug all the way in until the spring clip on the

bottom of the plug clicks into place (Fig. 6).

1915

Figure 6

1. Spring clip

6. Release the discharge door handle to lock the top of the

plug.

Installing the Fuse

Electric-start Model only

The fuse protects the electric start system. If the battery

does not charge or the engine does not turn with the electric

starter, the fuse may be blown. Use a 40-amp plug-in type

fuse.

1. Remove the battery box cover (Fig. 7).

m-5146

Figure 7

1. Battery box 2. Battery box cover