Service Manual

Engine Removal (cont’d)
5. Remove brake plate assembly by removing one
10 mm shoulder screw and one 3/8 washer-
head screw. Place the assembly on the mower
deck and disconnect the ground wire (that goes
to the CD Pack).
(Figure 66).
9. On self-propelled models only, remove the 5/16
screw to remove the belt drive cover. Remove
two
3/8” screws with spacers that secure the belt
drive guide bracket to the drive unit
(Figures
67
& 68). Remove the drive belt from the pulley
(belt will stay with the engine as cover is
removed).
Figure 66
7. Remove the CD Pack (page 41).
Note: Step 8 covers ‘93 carburetors; ‘94
carburetors have an additional wire holder that
must be released to remove the air cleaner
element. Mounting screws are identical.
8. Snap open the air cleaner cover (catch on left,
hinge on right) and remove the air filter element.
Remove the
two screws securing the carburetor
to the engine. Disconnect the fuel line from the
carburetor. Separate the carburetor from the
engine with controls attached and set it on the
mower deck.
Figure 67