Service Manual
LMR-16 Carburetor Assembly (cont’d)
10. Place a drop of Loctite on the screw and install
the throttle shaft and valve with the valve hole to
the left
(Figure 23).
Figure 23
1 1. Place the governor spring into the collar and
place the collar and spring onto the throttle shaft.
Position the collar
so
that the window is in line
Figure 24
with the pulse hole
(Figure 24).
12. Install the air vane and screw
(Figure 25).
Figure 25
LMR-16 Carburetor Presetting the
Governor
1. Hold the carburetor with the mounting flange
facing you and the throttle wide open.
2.
Preset the governor by turning the collar
so
that
the window on the collar is
3-4
clicks to the right
of the pulse hole.
LMR-16 Carburetor Assembling Air
Box
to Carburetor
1. Hook the end
of
the governor spring into the
control lever and move the air box
counterclockwise.
2. Lift the control lever over the choke shaft and
place on the front
of the carburetor. Make sure
the post on the lever activates the choke.
3.
Install the carburetor mounting bolts
(Figure 26).
?
Figure 26
4.
Place one carburetor-to-crankcase gasket onto
5.
Install the heat shield as shown
(Figure 27).
the carburetor for mounting bolts.
AIR
VANE
Figure
27
Service Section 29 Carburetor
I