Service Manual

5-10
WPM Drive Systems Manual
THREESPEEDTRANSMISSION
2. Slide the intermediate shaft gears onto the
intermediate shaft in this order:
a. 25 tooth gear
b. 20 tooth gear
c. 15 tooth gear/bevel gear
3. Slide 2 spacer washers onto the intermediate
shaft next to the bevel gear and follow with an
intermediate shaft bushing, anged side rst.
4. Drop the intermediate shaft into the gear case,
making sure that all gears engage properly.
5. Fill the gear case with 6 oz. (177cc) of No. 2 lithium-
based grease, then install the cover with the six
anged head self-tapping capscrews.
6. Secure the input pulley nut.
Installation
For assembly, reverse the removal process.
Torque the belt guide fasteners to 130 in-lbs. (15 Nm)
(Fig. 129).
IntermediateShaftAssembly
Note: Beforeassembling,coattheintermediate
shaftwithNo.2lithium-basedgrease.Applya
lightbeadoflithium-basedgreasetoange.
1. Slip an intermediate shaft bushing onto the left end
of the intermediate shaft, anged end rst (Fig. 128).
Fig128 g. 102
Fig129 3428-0196
A. Bushings C. Spacers
B. Gears