Service Manual
8-8
WPM Drive Systems Manual
BBC/BOS/BCS
6. Slide the rocker arm assembly over the upper
carriage bolt and sleeve making sure that the sleeve
passes through the cable lever. Also make sure that
the roll pin passes through the hole in the control
bar.
7. Release the BBC cable lever from the control hood
and install the BBC cable into the cable lever (Fig.
190).
Note: TheBBCcableleverisbehindthespring.
3. Place a piece of duct tape over the heads of the
carriage bolts that slide through the handle and the
left control box housing. This will aid in assembly.
4. Slide the sleeve onto the upper carriage bolt making
sure that it passes through the control bar, traction
lever, and left control housing.
5. Position the control hook and torsion spring in the
rocker arm as shown in Figure 189. Secure with the
roll pin making sure that the roll pin is ush with the
side indicated in the gure. Loosely install the BBC
cable lever as indicated. When correctly installed,
the control hook and the cable lever will be engaged.
Fig189 g 35
Fig190 g 36
A. Control hook C. Cable lever
B. Roll pin ush with
this side
A. BBC cable lever B. BBC cable