Service Manual

4-25
WPM Drive Systems Manual
SINGLESPEEDBEVELGEARTRANSMISSION
3. Install the transmission bearings with the ange
facing the gear (Fig. 109).
TransmissionInstallationTips
1. Reconnect the cable to the belt guide and install the
washer and spacer before installing the guide on the
transmission.
2. Install the snap rings and clip rings with the sharp
side out (in the direction of the force). The left end
of the axle uses the extra thrust washer, the one
without the tab. Install the snap ring, the regular
thrust washer then the thrust washer with the tab.
3. Coat the axle, key, and spring with #2 molybendum
disulde grease or anti-seize compound before
installing the pinion (Fig. 111).
Fig111 MVC-472
Fig109 MVC-470
4. Fill the transmission approximately 2/3 full with #2
Lithium base grease (1.5 oz or 43gm).
5. Assemble the bearings and bearing retainers; install
the transmission in the housing (Fig. 110).
Fig110 MVC-301Xa