Service Manual

Rewind Starter Assembly
1. Lubricate the center post of the rewind starter with a
small amount of general purpose grease.
2. Place the reel assembly on the center post of the
rewind starter and turn the reel counterclockwise until
the hook on the reel spring engages the spring retainer
on the center post of the starter. See Figure
28.
I
Figure 28
3. Install the dog springs and the brake spring as shown
in Figure
29.
Figure 29
Rewind Starter
28
4. Install the friction disc retainer and retaining screw.
See Figure
30.
SCREW
Figure 30
5. Drive the aligning roll pin into the center of the retain-
ing screw and slide the plastic sleeve over the pin. See
Figure
31.
Figure 31
Rewind Starter Installation
1. Install the rewind starter on the blower housing, cen-
tering the aligning pin in the opening
in the end of the
crankshaft.
2. Install the four 5/16" hex, washer head retaining
screws and tighten to
40 in Ibs (4.5Nm).
GTS150