Service Manual
4-11
WPM Drive Systems Manual
SINGLESPEEDBEVELGEARTRANSMISSION
3. Remove the plug from the hole next to where the
self-propel cable goes through the chassis (Fig.
062).
5. The cable tool (P/N 105-6819) will compress the
locking tabs on the cable so it can be removed from
the housing.
6. Slide the cable tool over the end of the cable and
push (Fig. 064). At the same time, reach around the
mower and pull the cable out of the housing.
7. With the plug removed from the larger hole next to
the cable, move the cable through the slot (Fig. 065).
Fig065 PICT-1904
4. Tip the mower on its side. The cable snaps in from
the top and connects to an arm on the transmission
belt guide (Fig. 063).
Fig063 PICT-1884a
A. Cable B. Belt guide
A
B
Fig064 PICT-1895a
A
A. Cable tool
Fig062 MVC-735