Service Manual

4. Install a new inlet valve needle and clip on
5. Install the float assembly with a new float
hinge pin in the bottom
of the carburetor.
Ensure the hinge pin is positioned properly
to keep the float level. The float should be
free to move up and down easily in the
carburetor body.
the float.
4
6. Adjust the float so the height is 15/32" to
17/32" (11.9 13.5 mm) from the bowl
flange (without the gasket in place) to the
top of the float.
7.
8.
Install the fuel filter over the nozzle.
Install a new fuel bowl gasket and the fuel
bowl with the four bowl retaining screws.
Service Section 5-11