Service Manual

2. Install the governor lever on the governor shaft, leave
the lever loose at this time. See Figure 92.
. . .. .
Figure 92
Carburetor - Installation
1 . Install the carburetorthrottle arm on the “Z” bend of the
governor link rod. The
“Z bend is installed from the top
through the bushing in the arm on the top of thethrottle
shaft.
2. Install the carburetor gasket/insulator and carburetor
on the block of the engine. Torque the screws to
60 in
Ibs
(6.8 N-m). See Figure 93
Figure 93
3. Hook the governor link spring on the throttle bracket
assembly. See Figure 94.
Figure 94
4. Install the choke over center spring. See Figure 95.
Governor
- Adjustment
1. To adjust the governor the following sequence of
component installation must be followed:
a. Install the link rod on the governor arm and
b. Install the governor lever on the governor shaft
-
carburetor.
leave
it loose.
c. Install the carburetor on the engine.
d. Attach the link rod spring.
position.
3. Rotate the governor shaft fully counterclockwise and
tighten the governor lever locking nut to
35 in Ibs (4
N-m).
2. Rotate the carburetor throttle shaft to the
full throttle
Electric Starter
- Installation
1. Install the electric starter (if equipped) with two 3/8”
hex washer head screws. Torque the screws to 85 in
Ibs (9.5
N-m). See Figure 96.
.
Figure 96