Service Manual

9-11

WPM Drive Systems Manual

HANDLES&CONTROLCABLES

CableAdjustment

The engine brake cable is not adjustable. If it fails to

function it will need to be replaced.

Self-PropelCable

To properly adjust the self-propel cable, loosen the cable

clamp, pull the cable downward to remove all the slack

(Fig. 283) then push the cable jacket up 1/8” (3.17cm)

(Fig. 284) and secure with the cable clamp.

HandleDisassembly,Lawn-BoyBlade

ClutchSystem(BCS)Models

1. Remove the upper wire bail. On the right hand side

it slides over a pin. On some models this pin has a

push nut on it (Fig. 285). It can be compressed so

that either the bail slides off the pin or it draws the

pin out of the handle. Either is acceptable.

Fig283 G002635_a

Fig285 DSC-4871a

1. Cable

Fig284 G002634_a

1. Cable clamp 2. Cable

Fig286 DSC-4896a

A. E-clip

2. Remove the e-clip on the left side pivot pin (Fig.

286).