Service Manual
9-10
WPM Drive Systems Manual
HANDLES&CONTROLCABLES
Assembly
If the handle has been binding, clean the top slides and
the sleeves before assembling. Dirt and grit in the sliding
part of the handle can cause a bind.
Assemble in reverse order. When you install the upper
handle, line up the holes and install the pivot pins (Fig.
282).
4. Slide the pin out of the left hand handle and pull the
upper handle up and out.
5. The plastic sleeves will slide off the upper handle.
6. The springs can be removed from the top slides if
necessary.
3. Remove the shoulder bolt and the traction lever (Fig.
281).
Fig281 DSC-4880a
Fig282 DSC-4885a