Operator's Manual

2. Filling the Engine with Oil
Y our mo w er does not come with oil in the engine .
1. R emo v e the dipstic k ( Figure 7 ).
Figure 7
2. Slo wl y pour oil into the oil fill tube until the oil lev el
reac hes the Full line on the dipstic k ( Figure 7 ). Do not
o v erfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30W
deterg ent oil with an API ser vice classification of SF ,
SG , SH, SJ , SL, or higher .)
3. Install the dipstic k securely .
Important: Change the engine oil after the fir st 5
operating hour s ; change it y ear l y ther eafter . R efer
to Changing the Engine Oil.
3. Installing the Fuse
Y our mo w er comes with a 40-amp fuse that protects the
electric star ter .
Important: Y ou cannot star t the mo w er with the
electric star ter or charge the batter y unless y ou install
the fuse.
1. Unclip both ends of the batter y co v er and remo v e it
( Figure 8 ).
Figure 8
2. Install the fuse in the fuse holder ( Figure 9 ).
Figure 9
Note: Y our mo w er comes with a fuse in the y our
o wner’ s pac k et and another fuse in the batter y bo x.
3. Install the batter y co v er .
4. Charging the Battery
R efer to Charging the Batter y in the Maintenance section.
Product Overview
Figure 10
1. Upper handle 8. Spark plug
2. Handle knob (4) 9. Cutting height lever (4)
3. Battery (not shown)
10. Oil ll/Dipstick
4. Fuel tank cap 11. Recoil start handle
5. Side discharge 12. Electric starter
6. Air lter 13. Blade control bar
7. Primer
Figure 11
1. Grass bag 3. Battery charger
2. Side discharge chute
4. Rear discharge plug (installed)
6