Operator's Manual

20
420
1
2
3
Figure 33
1. Discharge tunnel
2. V ertical bolts
3. Horizontal bolt
4. Fasten the front right, rear right, and rear left corners
of the dischar ge tunnel to the mower , using the bolts
saved from step 2. Ensure that the shorter horizontal
bolt is installed in the front right location.
5. Secure the spring bracket and discharge tunnel to the
mower with the left front bolt (Fig. 34). A socket set
extension may be necessary (Fig. 35).
1911
1
2
3
Figure
34
1. Spring
2. Spring
bracket
3. Left front bolt
505
1
2
Figure
35
1. Socket set extension 2. Spring bracket
6. Hook the end of the spring through the small hole on
the spring bracket (Fig. 34).
7. Open and close the dischar ge door to ensure that the
spring is not contacting any part of the engine and that
the door closes when the handle is released.
WARNING
POTENTIAL HAZARD
• Ensure that the spring does not contact the gas
tank or any other part of the engine.
WHAT CAN HAPPEN
• Wear between the spring and engine parts may
r esult in an unsafe operating condition.
HOW TO AV OID THE HAZARD
• If the spring contacts any part of engine, do not
install the bagger kit on the mower and contact
an Authorized T or o Service Dealer befor e
proceeding.
Using the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Ensure that the dischar ge door handle is fully forward
and the pin is engaged in the catch (Fig. 36).
1912
1
3
2
Figure
36
1. Bag frame on retaining
post
2.
Pin contacting latch plate
3. Handle fully
forward–discharge door
closed
3. Slide the hole in the bag frame onto the retaining post
on the dischar ge tunnel (Fig. 36).
4. Set the rear of the bag frame onto the lower handle.
5. Open the dischar ge door by pulling the dischar ge door
handle forward until the pin clears the ramp on the bag
door and moving the handle rearward until the pin
locks in the bag notch (Fig. 37).