Service Manual

4-23

WPM Drive Systems Manual

SINGLESPEEDBEVELGEARTRANSMISSION

16. Push the transmission to the left, as shown, and

rotate to clear the tunnel. Drop the left side down,

then pull the assembly out to the left side (Fig. 104).

Fig102 MVC-211X1

15. Remove the nut, washer, 2 pulley halves, and

spacer from the transmission input shaft. Remove 2

screws securing the belt guide to the transmission

(Fig. 103).

Fig103 PICT-1926a

A. 2 screws on top D. Pulley half

of transmission E. Washer

B. Spacer F. Nut

C. Pulley half

Fig104 MVC-300X

17. The last step is to slide the bearings and bearing

retainers off the axle (Fig. 105).

Fig105 MVC-301X