Operator's Manual

27
Changing the Transaxle Fluid
Change transaxle fluid every 800 operating hours or yearly,
whichever occurs first.
1. Position the vehicle on a level surface, set the parking
brake, turn the ignition off, and remove the key.
2. Remove the drain plug from the right side of the
reservoir (Fig. 29) and let the fluid flow into a drain
pan. Install and tighten the plug when the fluid stops
draining.
Note: Dispose of the used oil at a certified recycling center.
1
m–4849
2
Figure 29
1. Drain plug 2. Level indicator hole
3. Fill the reservoir (Fig. 30) with approximately 1-1/2 qt.
(1.4 liters) of SAE 10W30 motor oil or until the oil
level is at the bottom of the level indicator hole
(Fig. 29).
1
Figure 30
1. Oil fill
4. Start engine and operate to fill system. Recheck oil
level and replenish, if required.
Replacing the Fuses
There are 4 fuses in the electrical system. They are located
beneath the bed in a box on the right hand side of the frame
(Fig. 31).
Low oil light, hour meter 10 amp.
Headlights 10 amp.
Charge circuit 25 amp.
Power point 10 amp.
(15 amp. max.)
m–5362
321
4
Figure 31
1. Charge circuit
2. Headlights
3. Power point
4. Low oil light, hour meter
Replacing the Headlight Bulbs
Replacement bulb: GE #862
1. Set the parking brake, turn the ignition off, and remove
the key. Switch the headlights off.
2. Reach beneath the dash and rotate the lamp assembly
1/4 turn counterclockwise (Fig. 32). Pull the lamp
assembly out of the reflector.
3. Remove the lamp assembly from the wire harness.
Discard the lamp assembly.
1
m–4849
2
3
4
Figure 32
1. Lamp assembly
2. Reflector
3. Tabs
4. Slots