Service Manual

4-14
WPM Drive Systems Manual
SINGLESPEEDBEVELGEARTRANSMISSION
20. The cable may be unhooked from the arm on the
transmission to help prevent cable damage (Fig.
076).
Note: Itisnotnecessarytoremovethetransmission
toreplacethecontrolcable.
21. Pull the belt towards the crankshaft and remove.
Ifonlythebeltistobereplaced,installanewone
now.Reversetheprocesstoassemble.
Iftransmissionserviceisnecessaryproceedas
follows.
18. Pull the belt cover out from under the rear wall and
the belt is exposed (Fig. 074).
Fig074 MVC-745
19. Clamp the axle with locking pliers and remove the
pulley nut and transmission pulley (Fig. 075).
Do not bend the belt guide. The pulley must be lifted
up slightly to slip the belt off.
Fig075 MVC-740
Fig076 MVC-741