Service Manual

9-6
WPM Drive Systems Manual
HANDLES&CONTROLCABLES
This is the second generation of the Personal Pace/
Easy Stride handle assembly. It works the same as the
original in the sense that the handle is telescoping. As
the handle is depressed it tightens the self-propel belt
and drives the transmission.
Disassembly
To ease removal of the Personal Pace handle from a 22”
Recycler, make a tool from a piece of metal strapping
or banding material. You will need two pieces about 5”
(12.7cm) long each. Bend them as shown in the photo
and round the ends to remove burrs. This tool permits
the handle to slide up and over the internal handle stops
(Fig. 271).
1. Disconnect the control cables and the key switch
(electric start models) from the upper handle and
Personal Pace handle. Separate the upper and
lower handle. Remove the brake bail by pressing the
two ends together until they come out of the holes in
the handle.
AdjustingthePersonalPaceCable
Ensure the transmission belt is disengaged, transmission
tilted forward. Loosen the cable clamp on the handle.
When you pull the cable down the personal place handle
should raise to the stop. Hold the cable and secure the
clamp (Fig. 269).
Fig269 DSC-4829a
Fig271 MVC-712Xa
PersonalPaceGeneration2/Easy
StrideGeneration2
Fig270 tco_s_wpm_20018_handle