Operator's Manual

10 se c t i O n 4 — as s e M b l y & in s t a l l a t i O n
Install the bagger cover onto the bag support assembly, as 5.
seen in Fig. 4-11. The plastic cover goes in between the two
mounting tabs.
Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place
on the tractor, follow these steps to assemble the remaining
bagger components.
Snap the plastic upper chute support in place by first 1.
clipping the side portion onto the bagger support rail (1)
with the edge of the snap feature aligned with the red line,
as seen in the inset of Fig. 4-8.
Snap the front side of the chute support to the rail (2), as 2.
shown in Fig. 4-8.
Install the bagger screen into the bagger cover by first 3.
inserting the end closest to the center into the cutout
mounting hole, as in Fig. 4-9. Make sure to feed the screen
under the lip, as in Fig. 4-10.
Clip in the other side by flexing the screen and pushing it 4.
down into the provided cutout hole. See Fig. 4-10.
1
2
Figure 4-8
Cover mounts in
between these
two tabs
Figure 4-9
Figure 4-10
Figure 4-11
Make sure screen sits under the cover’s lip