Service Manual
9-7
WPM Drive Systems Manual
HANDLES&CONTROLCABLES
2. Install the tool over the stop in the handle guides as
shown, one on each side. Push the handle down.
The tool will allow the handle to slide over the stop
built into the handle guide (Fig. 272).
4. Continue pushing the handle down until it slides off
the end of the upper handle (Fig. 274).
Fig272 MVC-005Xa
Fig274 MVC-709Xa
5. When reinstalling the handle, reconnect the spring
as shown. The spring should push the handle
upwards toward the disengage position (Fig. 275).
Fig275 MVC-710Xa
3. As the handle begins to slide downward, pull the
traction control bar farther out of the handle (Fig.
273).
Fig273 MVC-707Xa
A. Traction Control Bar
A