Installation Instructions

g362548
Figure9
1.Push-inharnesstie3.2-socketconnector
(machinewireharness)
2.2-pinconnector
(operator-presence
switch)
3.Plugthe2-socketconnectorofthemachine
wireharnessintothe2-pinconnectorofthe
operator-presenceswitch.
4.Securethewireharnesstothebottomofthe
seatwiththepush-inharnesstie.
5.Aligntheholesintheseatbaseangesontothe
studsintheseatisolators(Figure10).
g363340
Figure10
1.Flangelocknuts(3/8inch)2.Stud(seatisolator)
6.Threadthe4angelocknuts(3/8inch)ontothe
studsintheisolators.
7.Torquetheange-headcapscrewsto1978to
2542N∙cm(175to225in-lb).
8.Torquetheangelocknuts(3/8inch)to37to45
N∙m(27to33ft-lb).
7
TestingtheOperator’s
PresenceSwitch
NoPartsRequired
Procedure
1.Sitintheoperator'sseat,ensurethetraction
controlsareintheNEUTRALposition,andthe
parkingbrakeisengaged.
2.Starttheengine.
3.Riseofftheseatandmovethetractioncontrol
forward.
Note:Theengineshouldshutoff.
4.Iftheenginerunswhileyouareofftheseat,
andyoumovedthetractioncontrol,performthe
followingsteps:
A.Shutofftheengine.
B.Waitforallmovingpartstostop.
C.Removetheange-headcapscrewsand
washers.
D.Tilttheseat,checkthewireharness
connectionattheoperator-presenceswitch.
E.Installtheseatwiththeange-head
capscrewsandwashers,andtorquethe
capscrewsto1978to2542N∙cm(175to
225in-lb).
F.Repeatsteps1through3.
5.Shutofftheengineandwaitforallmovingparts
tostopbeforeleavingtheoperator’sseat.
4