Installation Instructions

ManualsBrandsToro ManualsCompact Utility LoadersLight Kit, Dingo TX 1300 Compact Tool Carrier

FormNo.3451-209RevA

LightKit

Dingo

TX1300CompactToolCarrier

ModelNo.140-4508

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Light2

Brackets2

Largebolt2

Smallbolt

Largenut2

Smallbolt

Installthelights.

Cabletie

Connectthelights.

Nopartsrequired

–

Completetheinstallation.

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Lowertheloaderarms.

4.Shutofftheengineandremovethekey.

5.Openthehood.

6.Turnthebattery-disconnectswitchtotheOFF

position.

7.Accesstheplug,

WARNING

Usingadrillwithoutpropereye

protectionmayallowdebristoenterthe

eye,causinginjury.

Whendrilling,alwaysweareye

protection.

•Ifyourmachinehasaplug,removetheplug

onthedashtoaccessthewireharness.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3451-209*

Summary of content (4 pages)

PAGE 1
Form No. 3451-209 Rev A Light Kit Dingo® TX 1300 Compact Tool Carrier Model No. 140-4508 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Prepare the machine. 2 Light Brackets Large bolt Small bolt Large nut Small bolt 2 2 2 4 2 4 Install the lights. Cable tie 2 Connect the lights. No parts required – Complete the installation.
PAGE 2
Installing the Lights Parts needed for this procedure: 2 Light 2 Brackets 2 Large bolt 4 Small bolt 2 Large nut 4 Small bolt g379176 Figure 1 • If your machine does not have a plug, drill a 1-inch hole into the control panel. Procedure 1. Install the lights to the brackets using 2 large bolts and 2 large nuts. g379724 Figure 2 1. 2.36 cm (0.93 inch) 8. 2. 5 cm (2 inches) Pull the plug through the hole. g379047 Figure 3 2.
PAGE 3
g379044 Figure 4 3. Install the rear light assembly using 2 small bolts and nuts. g379175 Figure 6 2. Remove the rear cover and route the rear harness under the rear screen. Use the magnetic wiring harness mount to keep the wiring away from the operator and rear screen. 3. Connect the rear light to the harness and secure with a cable tie. g379045 Figure 5 3 Connecting the Lights g379177 Parts needed for this procedure: 2 Figure 7 Cable tie 4. Procedure 1.
PAGE 4
Operation 4 Operating the Lights Completing the Installation Push the switch to turn on the lights. No Parts Required Procedure 1. Turn the battery-disconnect switch to the ON position. 2. Close the rear-access cover. 3. Close the hood. 4. Start the machine and verify that the lights function using the switch.