Installation Instructions

FormNo.3442-713RevA

ReverseTowKit

Groundsmaster

4500/4700-DSeriesRotaryMowerorReelmaster

7000-DSeriesTractionUnit

ModelNo.136-3620

InstallationInstructions

Installation

Note:Determinetheleftandrightsidesofthe

machinefromthenormaloperatingposition.

PreparingtheMachine

NoPartsRequired

Procedure

Thefollowingstepsarestandardforkitinstallation;

followthemascloselyastheindividualsituation

allows.

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Lowerthecuttingunit.

4.Shutofftheengineandremovethekey.

InstallingtheHose

Partsneededforthisprocedure:

1Hose

Straighttting

1Hydraulicplug

Procedure

1.Installthestraightttingstotheendofthehose

asshowninFigure1.

Note:EnsuretheO-ringsareonthettingsand

lubricatedwithhydraulicoil.

g342444

Figure1

1.Straighttting

3.Hose

2.O-rings

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3442-713*

PAGE 1
Form No. 3442-713 Rev A Reverse Tow Kit Groundsmaster® 4500/4700-D Series Rotary Mower or Reelmaster® 7000-D SeriesTraction Unit Model No. 136-3620 Installation Instructions Installation Note: Determine the left and right sides of the machine from the normal operating position. 1 Preparing the Machine No Parts Required Procedure The following steps are standard for kit installation; follow them as closely as the individual situation allows. 1. Park the machine on a level surface. 2.
PAGE 2
. Remove the diagnostic fitting from the port in the hydraulic line (Figure 2). Save the fitting for after towing has been completed. 3. Remove the plug from the port in the rear traction manifold (Figure 3). Discard this plug. 4. Install the hose to the port in the hydraulic line under the filter on the right side of the machine (Figure 2). g342445 g342449 Figure 2 1. Filter 3. Right-front tire 2.
PAGE 3
5. Install the hose to the rear traction manifold between ports M8 and P2 as shown in Figure 3. g342448 Figure 3 1. Hose 2. Hose installed in the manifold 6. Review the Pushing or Towing the Machine procedure in the Operator’s Manual. 7. Release the parking brake and keep the cutting units as low as possible. 8. Tow the machine. 9. After the towing, remove the hose from the manifold and the port near the filter. 10. 3. Left-front tire 4.
PAGE 4