Installation Instructions

5
7. Lightly oil the ends
of the center roll bar
section.
8. Loosely install the
center roll bar section,
using 2 bolts
(1/2 x 3-1/4 inches) and
2 flange nuts (1/2 inch).
Note: Make sure the
bolts are installed on the
outside of the roll bar.
Note: Make sure the
lanyard tab is installed
as shown and points
forward.
m–6891
9. Raise the roll bar
into the upright position
and secure it with the
pins and hairpin cotter
pins fastened to the
lanyards.
m–6893
10. Tighten the center
roll bar bolts
(1/2 x 3-1/4 inches) so it
rotates freely with some
resistance.
Note: No more than one
thread should be
exposed outside the nut.
11. Torque all lower
fasteners, attached to
the machine frame, to
30 ft–lb.
m–6891
12. Tighten the front
handles against the
center roll bar ends.
13. Tighten the rear
bumper bolts.
m–683
5
Step
3
Installing the Drive Wheels
Parts needed for this step:
Qty. Part
2 Rear wheels
Procedure
1. Mount the wheels
with the valve stem to
the outside and secure
them with the nuts or
bolts previously
removed in Step 1.
2. Torque the nuts or
bolts to 95 ft-lb
(128 N⋅m).
m–6859