Service Manual

ProCore SR Series Page 3 -- 13 Chassis
Hydraulic Top Link
1. Shaft
2. Cap screw (2 used)
3. Retainer plate
4. Retaining ring
5. Wiper
6. Head
7. Back--up ring
8. O--ring
9. Back--up ring
10. O--ring
11. Back -- up ring
12. O--ring
13. Piston
14. O--ring
15. Lock nut
16. Spacer
17. Adapter
18. Barrel
19. Pin
20. Cotter pin
Figure 15
2
3
6
8
9
10
11
13
18
5
7
12
14
15
4
16
17
19
2
1
16
20
For machine serial numbers below 320000000
Disassembly ( Fig. 15)
1. Remove hydraulic top link from aerator and tractor
(Fig. 17).
2. Remove spacers (item 16) from cylinder shaft clevis
and adapter on barrel end.
3. Remove oil from hydraulic cylinder into a drain pan
by slowly pumping the cylinder shaft. Plug both cylinder
ports and clean the outside of the cylinder.
4. Remove two (2) cap screws that secure retainer
plate to head. Position plate away from cylinder barrel
to allow access to retaining ring (item 4).
Chassis