Service Manual

Chassis Page 6 – 26
Sand Pro & Infield Pro 3040/5040
Operator Seat
1. Operator seat
2. Flange nut (8 used)
3. LH seat adjuster
4. Carriage screw (4 used)
5. Seat shroud
6. Receptacle
7. Rivet
8. Screw
9. Holding post
10. Bumper (2 used)
11. Jam nut (4 used)
12. Clevis pin (2 used)
13. Hair pin (2 used)
14. Lock nut
15. Spacer
16. Cap screw (4 used)
17. Lock washer (4 used)
18. Flat washer (4 used)
19. RH seat adjuster
20. Seat base
21. Seat switch
Figure 16
FRONT
RIGHT
6
7
8
10
11
12
9
13
2
3
4
1
5
14
2
21
15
16
17
18
19
20
Removal (Fig. 16)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
2. Tilt seat up and disconnect wire harness electrical
connector from the seat switch.
3. Remove seat components as necessary using Fig-
ure 16 as a guide.
Installation (Fig. 16)
1. Install seat components using Figure 16 as a guide.
2. Connect wire harness electrical connector to the
seat switch.