Operator's Manual

Figure 32
1. Center shroud
3. Raise the front wheel and one rear wheel off
of the floor and place suppor t bloc ks under
the frame .
T he fr ont wheel and one r ear wheel must
be raised of f the g r ound or the machine
will mo v e during the adjustment. Mak e
sur e the machine is suppor ted so it will
not accidentall y f all injuring an y one
under the machine.
4. Loosen the loc kn ut on the traction adjustment
cam ( Figure 33 ).
Figure 33
1. Traction adjustment cam
3. Screw
2. Locknut
4. Gap
T he engine must be r unning so that
the final adjustment of the traction
adjustment cam can be perf or med.
Contact with mo ving par ts or hot
surf aces may cause per sonal injur y .
K eep hands, feet, f ace, and other body
par ts a w ay fr om r otating par ts, the
muf fler , and other hot surf aces.
5. Star t the engine and rotate the cam hex
( Figure 33 ) in both directions to deter mine the
mid position of the neutral span.
6. Tighten the loc kn ut securing the adjustment.
7. Stop the engine .
8. Install the center shroud.
9. R emo v e the jac k stands and lo w er the mac hine
to the shop floor . T est dri v e the mac hine to
mak e sure that it does not mo v e when the
traction pedal is in neutral.
Adjusting the Traction
Interlock Switch
1. Adjust the transmission for neutral; refer to
Adjusting the T raction Dri v e for Neutral.
2. Acti v ate the pump lev er to ensure that all par ts
are operating freely and seated properly .
3. Adjust the screw until the air g ap is .060 inc hes
±.030 ( Figure 33 ).
4. Chec k for proper operation.
Adjusting the Transport
Speed
Obtaining Maximum Transport Seed
T he traction pedal is adjusted for maxim um
transpor t speed and rev erse at the factor y , but an
adjustment ma y be required if the pedal reac hes full
strok e before the pump lev er reac hes full strok e ,
or if a decrease in transpor t speed is desired.
T o obtain maxim um transpor t speed, press do wn
on the traction pedal. If the pedal contacts the
stop ( Figure 34 ) before the pump lev er reac hes full
strok e , an adjustment is required:
30