Service Manual

Workman GTX ElectricPage 1 − 4Safety
Jacking and Other Instructions
Jacking Vehicle
DANGER
POTENTIAL HAZARD
• A vehicle that is not properly supported
may become unstable.
WHAT CAN HAPPEN
• The vehicle may move or fall. Personal
injury or damage to the machine may result.
HOW TO AVOID THE HAZARD
• Make sure vehicle is parked on a solid level
surface, such as a concrete floor.
• Make sure key switch is OFF and key is
removed from the switch before getting off
the vehicle.
• Before raising the vehicle, remove any
attachments that may interfere with the safe
and proper raising of the vehicle.
• Always chock or block wheels to prevent
the vehicle from rolling.
• Make sure proper hoists and jack stands
are used to raise and support the vehicle.
Jacking Locations
1. Jack front of the vehicle on the front of the frame be-
hind the towing tongue (Fig. 1).
2. Jack rear of the vehicle under each rear axle tube. Do
not jack vehicle below the transaxle case (Fig. 2).
1. Front of frame 2. Towing tongue
Figure 1
2
1
1. Rear axle tube 2. Transaxle case
Figure 2
1
2
1
Towing Vehicle
IMPORTANT: Frequent or long distance towing of
the Workman GTX Electric is not recommended.
In case of emergency, the vehicle can be towed for a
short distance. See Operator’s Manual for towing in-
formation.
IMPORTANT: If vehicle is towed, make sure that key
switch is in the OFF position, parking brake is re-
leased and key is removed from switch.
Transporting Vehicle
When moving the vehicle long distances, use a trailer or
flatbed truck. Make sure vehicle is secured to the trailer
properly. Also, make sure to secure seats to vehicle dur-
ing transport. See Operator’s Manual for transport infor-
mation.