Service Manual

Workman HDX Auto Page 8 − 15 Four Wheel Drive (Optional Kit)
Disassembly of Front Differential
1. Make sure that the oil is drained from the front differ-
ential assembly.
2. Remove the four (4) flange head screws from the in-
put cover (Fig. 9). Remove the cover.
3. Remove the pinion gear with bearing from housing
by pulling it out of the gear case by hand (Fig. 10).
4. Inspect the inner pinion bushing in the gear case
(Fig. 11). If the bushing is excessively worn, the gear
case must be replaced. The bushing is not serviced sep-
arately.
1. Input cover 2. Pinion gear shaft
Figure 9
2
1
1. Pinion gear shaft 2. Gear case
Figure 10
2
1
1. Pinion bushing 2. Gear case
Figure 11
2
1
Four Wheel Drive
(Optional Kit)