Service Manual

Workman HD Series Page 8 − 11 Electrical System
Headlight Switch
This headlight switch allows the headlights to be turned
on and off and is located on the dash (Fig. 9).
Testing
The headlight switch terminals are marked as shown
(Fig. 10). The circuitry of the headlight switch is shown
in the chart below. With the use of a multimeter (ohms
setting), the switch functions may be tested to determine
whether continuity exists between the various terminals
for each switch position. Disconnect wire harness con-
nector from headlight switch and verify continuity be-
tween switch terminals for each switch position.
SWITCH
POSITION
NORMAL
CIRCUITS
OTHER
CIRCUITS
ON 2 + 3 5 + 6
OFF 1 + 2 4 + 5
After testing is completed, connect wire harness con-
nector to headlight switch.
1. Dash 2. Headlight switch
Figure 9
1
2
Figure 10
BACK OF SWITCH
Electrical
System