Service Manual

Workman HD SeriesPage 6 − 34Drive Train
30.Disassemble differential fork shaft assembly:
A. Remove O−ring from fork shaft.
B. Remove snap ring, washer and spring.
C. Remove fork.
D. Remove lock pin if necessary.
1. O−ring
2. Snap ring
3. Washer
4. Spring
5. Fork
6. Lock pin
7. Fork shaft
Figure 53
6
543217
ARM
LOCK PIN
31.Disassemble L.H. axle shaft:
A. Remove O−ring from differential carrier.
B. Remove snap ring.
C. Remove L.H. axle shaft assembly.
D. Remove snap ring and washer.
E. Use a bearing puller to remove bearing from axle
shaft.
F. Remove oil seal from differential carrier.
32.Disassemble R.H. axle shaft:
G. Remove R.H. axle shaft assembly from seal cov-
er.
H. Remove snap ring and washer from axle shaft.
I. Use a bearing puller to remove bearing.
J. Remove washer and oil seal from seal cover.
L.H. SHAFT
R.H. SHAFT
1. O−ring
2. Snap ring
3. L.H. axle shaft assembly
4. Snap ring
5. Washer
6. Bearing
7. Oil seal
8. Differential carrier
9. R.H. axle shaft assembl
y
10. Snap ring
11. Washer
12. Bearing
13. Oil seal
14. Washer
15. Seal cover
Figure 54
5
6
7
4218 3
11 14 9
10 12
15 13
Drive Train