Service Manual
Table Of Contents
- Title Page
- Revision History
- Reader Comments
- Preface
- Table Of Contents (Page 1)
- Table of Contents (Page 2)
- 1 - Safety
- 2 - Product Records and Maintenance
- 3 - Kubota EFI Gasoline Engine
- 4 - Kubota Diesel Engine
- 5 - Kohler Air Cooled Gasoline Engine
- 6 - Drive Train
- 7 - Chassis
- Specifications
- General Information
- Special Tools
- Troubleshooting
- Service and Repairs
- Wheel Assembly
- Brake System
- Brake Caliper Service
- Bleed Brake System
- Parking Brake Caliper Service
- Brake Master Cylinder
- Brake Master Cylinder Service
- Parking Brake Cable
- Wheel Hub
- Steering Assembly
- Front Control Arms
- Front Compression Spring Service
- Front Shock Absorber
- Rear Shock Absorber
- Rear Leaf Spring
- Front Wheel Alignment
- Steering Wheel
- Seat Base
- Hood
- Windshield Wiper Assembly (Machines with Operator Cab)1. Flange- head screw (10 each)2. Sealing washer (10 each)3. Cab roof4. Bulb trim seal5. Console foam6. Fuse block mount7. Wiper motor8. Wiper motor bracket9. Roof console10. Clip
- 8 - Electrical System
- Electrical Schematics
- Special Tools
- Troubleshooting
- Electrical System Quick Checks
- Component Testing
- Ignition (Key) Switch
- Gauge Cluster
- Fuses
- Headlight Switch
- Clutch Switch(s)
- Brake Switch(s)
- Hydraulic Lift Lever Interlock Switch
- 3rd - High Lockout Key Switch
- Transaxle Switches
- Power Relay (Four Terminals)
- Relay (Five Terminals)
- Fusible Link
- Diodes
- Electronic Throttle Control (Workman HDX)
- Fuel Run/Stop Solenoid (Workman HDX-D)
- Fuel Gauge Sender (Workman HD & HDX-D)
- Fuel Pump/Sender (Workman HDX)
- Fuel Pump (Workman HDX-D)
- Temperature Sender (Workman HDX and HDX-D)
- Electric Fan Thermal Switch (Workman HDX-D)
- Speed Sensor
- Glow Controller (Workman HDX-D)
- High Flow Hydraulics Kit Switch (High Flow Hydraulics Kit)
- Hydraulic Solenoid Valve Coil (High Flow Hydraulics Kit)
- Rear PTO Switch (Optional Kit)
- Interlock Switch (1/3 Area Lift Platform Kit)
- Windshield Washer/Wiper Switch (Machines with Operator Cab)
- Diode Assembly (Machines with Operator Cab)
- Service and Repairs
- 9 - Hydraulic System
- Specifications
- General Information
- Special Tools
- Hydraulic Schematics
- Hydraulic Circuit Operation
- Troubleshooting
- Testing
- Primary Hydraulic System Gear Pump Flow Test (Workman HDX and HDX-D)
- Primary Hydraulic System Gear Pump Flow Test (Workman HD)
- Primary Hydraulic System Relief Valve Pressure Test
- Steering Control Valve and Steering Cylinder Test
- Lift Cylinder Internal Leakage Test
- High Flow Hydraulic System Gear Pump Flow and Relief Pressure Tests
- Service and Repairs
- General Precautions for Removing and Installing Hydraulic System Components
- Check Hydraulic Lines and Hoses
- Primary Hydraulic System Gear Pump (Workman HDX and HDX-D)
- Primary Hydraulic System Gear Pump (Workman HD)
- Primary Hydraulic System Gear Pump Service
- High Flow Hydraulic System Gear Pump Service
- Lift Valve
- Lift Valve Service
- Steering Control Valve
- Steering Control Valve Service
- Steering Cylinder
- Steering Cylinder Service
- Lift Cylinder
- Lift Cylinder Service
- Hydraulic Manifold (High Flow Hydraulics Kit)
- 10 - Front Wheel Drive (4WD)
- 11 - Electrical Drawings
- Electrical Drawing Designations
- Workman HD (Serial Numbers313000001 to 404350000)
- Workman HD (Serial NumbersAbove 404350001)
- Workman HDX (Serial Numbers313000001 to 401400000)
- Workman HDX (Serial Numbers401400001 to 404350000)
- Workman HDX (Serial NumbersAbove 404350001)
- Workman HDX--D (Serial Numbers313000000 to 314000000)
- Workman HDX--D (Serial Numbers314000001 to 401420000)
- Workman HDX--D (Serial Numbers401420001 to 404350000)
- Workman HDX--D (Serial NumbersAbove 404350001)
- Front Wire Harness: Workman HD (SerialNumbers 313000000 to 314000000)
- Front Wire Harness: Workman HD (SerialNumbers 314000001 to 401406000)
- Front Wire Harness: Workman HD (SerialNumbers 401406001 to 404350000)
- Front Wire Harness: Workman HD (Serial Numbers 404350001 to 409080000)
- Front Wire Harness Drawing(Serial Number above 409080000)
- Rear Wire Harness Drawing Serial Number below 409080000)
- Rear Wire Harness Drawing(Serial Number above 409080000)
- Front Wire Harness: Workman HDX (SerialNumbers 313000001 to 314000000)
- Front Wire Harness: Workman HDX (SerialNumbers 314000001 to 316000000)
- Front Wire Harness: Workman HDX (SerialNumbers 316000001 to 316999999)
- Front Wire Harness: Workman HDX (SerialNumbers 400000000 to 401400000)
- Front Wire Harness: Workman HDX (SerialNumbers 401400001 to 404350000)
- Front Wire Harness: Workman HDX (SerialNumbers 404350001 to 409100000)
- Front Wire Harness Drawing(Serial Number above 409100000)
- Rear Wire Harness: Workman HDX (SerialNumbers 313000001 to 315000500)
- Rear Wire Harness: Workman HDX (SerialNumbers 315000501 to 316999999)
- Rear Wire Harness: Workman HDX (SerialNumbers 400000000 to 401420000)
- Rear Wire Harness: Workman HDX (SerialNumbers 401420001 to 409100000)
- Rear Wire Harness Drawing(Serial Number above 409100000)
- Front Wire Harness: Workman HDX--D (SerialNumber 313000000 to 314000000)
- Front Wire Harness: Workman HDX--D (SerialNumber 314000001 to 316000000)
- Front Wire Harness: Workman HDX--D (SerialNumber 316000001 to 400000000)
- Front Wire Harness: Workman HDX--D (SerialNumber 400000001 to 401420000)
- Front Wire Harness: Workman HDX--D (SerialNumber 401420001 to 404350000)
- Front Wire Harness: Workman HDX--D (SerialNumber 4043500001 to 408000000)
- Workman HDX--D Front Wire Harness Drawing(Serial Number above 408000000)
- Rear Wire Harness: Workman HDX--D (SerialNumbers 313000000 to 400000000)
- Rear Wire Harness: Workman HDX--D (SerialNumbers 400000001 to 401420000)
- Rear Wire Harness: Workman HDX--D (SerialNumbers 401420001 to 408000000)
- Workman HDX--D Rear Wire Harness Drawing(Serial Number above 408000000)
- Front Wire Harness:Workman HDX--D (Industrial)
- Rear Wire Harness:Workman HDX--D (Industrial)
- Heater Kit--Wire Harness DrawingWorkman HD Series
Workman HD SeriesPage 8 − 28Electrical System
Glow Controller (Workman HDX−D)
The controller is located under the instrument panel.
NOTE: Refer to Electrical Diagrams − Chapter 11 in this
manual when troubleshooting the glow controller.
Controller Operation
1. When the ignition switch is placed in the RUN posi-
tion, the controller energizes the glow plug relay and illu-
minates the glow lamp for 10 seconds.
2. When the ignition switch is held in the START posi-
tion, the glow plug relay will energize while the switch is
held in START and the glow lamp will not illuminate.
3. When the ignition switch is released from START to
RUN, the glow plug relay will de−energize and the glow
lamp will remain off.
Controller Checks
1. Make sure there is power from the battery.
2. Disconnect electrical connector to the fuel stop sole-
noid to prevent the engine from starting.
3. Place ignition switch in the RUN position. Verify the
following while in the RUN position:
A. Glow indicator lamp is on.
B. Glow relay is energized.
C. Glow plugs are energized.
D. Glow indicator lamp goes out and glow plugs de−
energize after 10 seconds.
4. Place ignition switch in the START position. Verify the
following while in the START position:
A. Glow indicator lamp is out.
B. Glow relay is energized.
C. Glow plugs are energized.
D. Power exists at terminal 1 of the glow controller.
NOTE: If there is no power to terminal 1 of the glow con-
troller, verify continuity of the circuitry from the ignition
switch to the controller and perform Step 4 again (see
Electrical Diagrams − Chapter 11 in this manual).
5. If any of the conditions in Step 3 are not met or power
to terminal 1 exists and any of the other conditions in
Step 4 are not met:
A. Verify continuity of the circuitry from the battery to
the glow relay and glow plugs (see Electrical Dia-
grams − Chapter 11 of this manual).
B. Verify continuity of the circuitry from the battery to
ignition switch, glow controller, glow lamp, glow relay,
and ground (see Electrical Diagrams − Chapter 11 in
this manual).
C. Replace parts as necessary.
6. Connect electrical connector to the fuel stop solenoid
when finished.
1. Glow controller end view
2. Top view
3. Side view
Figure 40
3
2
1
6
4
5
2
3
1