Service Manual

Workman HD Series Page 6 − 23 Drive Train
Transaxle Service
Transaxle Disassembly
NOTE: Item numbers in figures are shown in order of
disassembly; for example, remove item 1 first, then item
2, etc. assemble transaxle in reverse order; for example,
install item 1 last.
1. Remove extension spring.
2. Loosen and remove flange head screws and remove
bell housing assembly from transaxle.
3. Thoroughly clean outside surface of transaxle.
1
2
1. Extension 2. Flange hd screw (9)
Figure 24
4. Loosen flange head screws and remove fork shaft
case from center plate. Note location of longer flange
head screw. Be careful when removing cover as steel
balls inside are spring loaded.
1
3
2
2
2
1. Flange head screw (1)
2. Flange head screw (3)
3. Fork shaft case
Figure 25
5. Hold your hand over the area and shift R−1 and 2−3
levers to move rails outward so balls, springs and
spindle can be removed.
6. Inspect fork shaft case for cracks or damage and re-
place if necessary.
1
2
3
1. Spindle
2. Spring (2)
3. Ball (2)
Figure 26