Operator's Manual

Figure55
1.Differential-lockcable3.Spring
2.Transaxlebracket
4.0.25to1.5mm(0.01to
0.06inch)gap
3.Adjustthejamnutstoobtaina0.25to1.5mm(0.01to
0.06inch)gapbetweenthespringhookandtheODof
theholeinthetransaxlelever.
4.Tightenthejamnutswhennished.
InspectingtheTires
ServiceInterval:Every100hours
Operatingaccidents,suchashittingcurbs,candamageatire
orrimandalsodisruptwheelalignment,soinspectthetire
conditionafteranaccident.
Checkthetirepressurefrequentlytoensureproperination.
Ifthetiresarenotinatedtothecorrectpressure,thetires
willwearprematurely.
Figure56isanexampleoftirewearcausedbyunderination.
Figure56
1.Under-inatedtire
Figure57isanexampleoftirewearcausedbyoverination.
Figure57
1.Over-inatedtire
CheckingtheFront-wheel
Alignment
ServiceInterval:Every400hours/Yearly(whichevercomes
rst)
1.Makesurethetiresarefacingstraightahead.
2.Measurethecenter-to-centerdistance(ataxleheight)at
thefrontandrearofthesteeringtires(Figure58).
Note:Themeasurementmustbewithin0±3mm(0
±0.12inch)atthefrontofthetirethenattherearof
thetire.Rotatethetire90°andcheckthemeasurement.
Important:Checkthemeasurementsatconsistent
locationsonthetire.Themachineshouldbeona
atsurfacewiththetiresfacingstraightahead.
Figure58
1.Frontofthemachine3.Centertocenterdistance
2.0±3mm(0±0.12inch)
fronttorearofthetire
3.Adjustthecenter-to-centerdistanceasfollows:
A.Loosenthejamnutatthecenterofthetierod
(Figure59).
48