Service Manual

Rev. A
Workman HDX/HDX--D Page 10 -- 17 Front Wheel Drive (4WD)
9. Carefully lift the ring gear out of the gear case (Fig.
17). Inspect ring gear teeth for any damage or abnormal
wear.
10.Remove the gear spacer from between the gear
case and the ring gear (Fig. 18).
IMPORTANT: When removing female output hub
from gear case, be careful to not damage the seal in
the gear case. The seal cannot be serviced sepa-
rately.
11.Turn the gear case over. Using a hammer and a suit-
able drift, carefully remove the female output hub and
bearingbydriving it intowardthe center ofthe gear case
(Fig. 19). The bearing has a slight interference fit to the
bore of the gear case. Take care to not damage the oil
seal in the gear case during hub removal.
1. Ring gear 2. Gear case
Figure 17
2
1
1. Gear spacer 2. Gear case
Figure 18
2
1
1. Drift
2. Gear case
3. Oil seal
Figure 19
2
1
3
Front Wheel
Drive (4WD)