Service Manual

Rev. A
Workman HDX/HDX--DPage 10 -- 18Front Wheel Drive (4WD)
12.Placethecoverplateontheworkbenchwiththemale
output hub facing up.
13.Using a screwdriver, remove the internal retaining
ring from the cover plate (Fig. 20).
14.Remove the gear spacer from the cover plate (Fig.
21).
15.Removethearmatureplatefromthec over plate(Fig.
22).
IMPORTANT: Whenremoving male output hub from
cover plate, be careful to not damage the seal in the
cover plate. The seal cannot be serviced separately.
16.Turn the cover plate over and place it on blocking or
in a vise. Using a hammer and suitable punch, carefully
remove the male output hub and bearing from the cover
plate by driving the output hub down. The bearing has
a slight interference fit to the bore of the cover plate. Be
careful to not damage the seal in the cover plate.
17.Discard the removed output hub assemblies. Clean
and inspect all removed parts.
NOTE: For additional front differential information, see
the Hilliard Front Drive Differential Parts and Service
Manual at the end of this chapter.
1. Male output hub 2. Retaining ring
Figure 20
2
1
1. Male output hub 2. Gear spacer
Figure 21
2
1
1. Male output hub 2. Armature plate
Figure 22
2
1