Service Manual

Rev. B
Workman HDX/HDX- DPage 10 - 4Front Wheel Drive (4WD)
Service and Repairs
CV Axle Assembly
1. Spindle nut
2. CV axle assembly
3. Differential assembly
4. Flange head screw (4 used)
5. Driveshaft
6. Cap screw
7. Flat washer
8. Wheel hub assembly
9. Tie rod assembly
10. Axle spacer
11. Flange head screw
12. Brake caliper (LH shown)
13. Brake rotor
14. Slotted hex nut
15. Cotter pin
16. Knuckle (LH shown)
Figure 1
FRONT
RIGHT
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
35 to 40 ft- lb
(48 to 55 N- m)
35 to 40 ft- lb
(48 to 55 N- m)
170 to 180 ft- lb
(231 to 244 N- m)
ANTISEIZE
LUBRICANT
ANTISEIZE
LUBRICANT
1
2
10
8
11
16
STAKED
Disassembly (Fig. 1)
1. Park vehicle on a level surface, shut engine off, re-
move key from ignition switch and apply parking brake.
2. For CV axle to be removed, remove wheel assembly,
brake caliper and brake rotor (see Brake System Disas-
sembly in the Service and Repairs section of Chapter 7
- Chassis).
IMPORTANT: Spindle nut (item 1) that secures CV
axle shaft to wheel hub is staked (deformed) to the
shaft during assembly. Clear away the deformed
area of the nut b efore removing the nut from the
shaft or damage to the shaft threads will occur.
3. Remove spindle nut (item 1) from the threaded shaft
of the CV axle. Discard spindle nut.